Roll black polymer clay into the log 0.9 cm thick. Follow the pattern for the arm bit.
(pattern is in download section of the site)
Cut a piece of clay about 1 cm long from the log and attach to the shoulder.
Smooth the joint.
For the stand: marble brown and yellow polymer clays
Make a rectangular 3cm long, 1.1 cm wide and 0.3 cm thick. Cover the stand with thin sheet of black clay.
Wheel: roll a log from black clay about 0.2 cm thick, cut 4 pieces 1 cm long. Cross them. Attach log of clay all around crossed logs.
Roll 2 tiny balls from black clay and attach to the centre of the wheel.
Cotton reel: roll two logs from black clay 0.6 and 0.3 cm long and 0.3 cm thick. Roll two balls 0.2 cm in diameter. Apply balls to the each side of the longer log. Place the shorter log on the top.
Needle = thin wire.
Assemble all the pieces together. Put piece of wood under the needle to support the "arm".
If you need a handle - do not forget to make one ;)
